SoundCraft Vi1, User Manual

Page: 163 / 217

Soundcraft Vi1™ User Guide Issue 0810 Page 15 - 27
Settings Recorded Within Audio Settings
This applies to the Show Snapshot and to any standard Cues.
All Channel* audio settings on the console: Channel ON; Fader positions; Pan; Channel Parameters (EQ/
Dynamics/input/output/ insert).
All Channel Bus assigns, levels, Pre/Post states and Channel Labels.
All Channel Patch settings.
All I/O controls.
*A ‘channel’ is an input, output or Master LRC channel.
Settings Not Recorded
PFL/SOLO switch status.
LRC Sel switch status.
All round Setup switch status.
User Defined switches (O/P fdr pnl) status.
All switches in Snapshot Control section.
Copy/Paste/Undo switch status.
Set Pre/Post modes switch status.
Pan/Level toggle switch status.
Upper & Lower Encoder Row Assign switches status.
Gang Mode switch status.
Solo Clear switch status.
Settings Restored To Their State At the Last Power-Down
Which Show was loaded.
LOAD ISO WITH SHOW switch status.
Show Compatibility
Vi4 and Vi6 Consoles
Shows which are saved on a Vi1 can be loaded on a Vi2, Vi4 or Vi6. All settings will be recalled except
for the channel pairing, which is not imported due to the differing vertical arrangement of channels in the
fader pages.
Shows which are saved on a Vi2, Vi4 or Vi6 can be loaded on a Vi1. Channels above 64 will be ignored
and will be deleted from the show when it is saved on the Vi1. Busses 25-32 will be ignored. The pairing
information is ignored as above.