SoundCraft Vi1, User Manual

Page: 66 / 217

Soundcraft Vi1™ User Guide Isuue 0810
Page 5 - 6
Bus Master Processing
The Bus Master processing is shown in the Input Meter Area of the upper half of the screen.
In order to change the parameters for EQ, Dynamics or Pan, the appropriate area on the touch-screen
must be pressed; doing so will open a page whose VST area is similar to the input channel screens.
HINT: Stereo Busses are linked. Therefore the processing strip will control both channels.
INPUT BAY STRIP USING [BUSSES 1-16] and [BUSSES 17-24]
The second method of controlling, and changing the parameters of the 24 output busses described earlier
is as follows.
If the [BUSSES 1-16] or [BUSSES 17-24] key is active, the input strips on all of the input bays will be
switched to control the 24 output busses.
Once this is done, the user can select the desired fader to control the required output level. In addition,
the VST encoders can be used to change the bus type (Aux, Grp or Mtx) and format (Mono or Stereo).
In order to change the parameters for EQ, Dynamics or Pan, the appropriate area on the touch-screen
above the required strip must be pressed; doing so will open a page similar to the input channel
processing.