SoundCraft RM1d, User Manual

Page: 46 / 142

46
RM1d/RM1ds User Guide
Meter Bridge Meter Bridge
Meter Bridge Meter Bridge
Meter Bridge
Meter Source Select Buttons
The main Left and Right meters (28) are either VU or PPM types depending on the options
specified at the time of purchasing your RM1d. The audio source which the meters display can
be selected by one of three source buttons.
The available sources are:
STEREO 1 (PROGRAM) Used to monitor the output of the Main STE 1 (PROG) bus
(Post Fader)
STEREO 2 (AUDITION) Used to monitor the output of the Main STE 2 (AUD) bus
(Post Fader)
MONITOR When selected the meters will display the signal currently
selected in the CONTROL ROOM monitor select panel.
Alternately the signal from any channel with a PFL (CUE)
button active will be displayed.
If SPLIT PFL (SPLIT CUE) mode is selected the LEFT meter will
display the PFL (CUE) signal, and the RIGHT meter the main
program output signal, during a PFL (CUE) condition.
NOTE: The 12 fader version of the RM1d has an additional pair of meters.
The available sources are: Stereo 1 (PROGRAM) Stereo 2 (AUDITION) or Monitor
These are selected from the 2nd meter source menu page
CUE Loudspeaker
The built-in CUE loudspeaker (29) can relay Reverse Talkback signals (i.e. Talkback from an
external location via the RTB IN connector on the rear panel of the RM1d), and signals from the
PFL (CUE) bus.
These signals are entirely independent of any Monitor Settings and can each be adjusted in
volume by using the associated controls marked REV TALKBACK and CUE. The CUE control
adjusts the overall loudspeaker volume, whereas the REV TALKBACK control only adjusts RTB
signal levels.
NOTE: The REV TALKBACK volume control CANNOT be turned all the way down (OFF). This is
normal to protect essential communications. The cue loudspeaker will automatically
mute along with the CONTROL ROOM MUTE button (19)
Dual Event Timers
The timers (30) can be triggered automatically from any of the channel faders* or manually
using the associated
START , STOP and RESET buttons.
NOTE: The TIMER 2 button directly below the timer buttons will allow you to switch these
controls between Timer 1 and Timer 2.
* see the Automatic operation 8.3 in Section 8 Timer Operation