Page 102
Appendices
I get an error message when I try to open the PowerKey Editor on my
Power Mac.
• Make sure that the system file “ObjectSupportLib” is in
the Extensions folder of your system, and hasn’t been
disabled by a startup controller utility.
My monitor and/or other peripherals turn off when I select “Re-
start”.
• Check all the Events in your Schedule which start with an
“At Shut Down” Trigger. If any of these Events contain a
“Switch Outlets” Action, they may turn off your outlets
when you select “Restart.”
A “Switch Outlets” Action is not necessary before a “Shut
Down Computer” Action, because the “Shut Down
Computer” Action can turn off the outlets itself.
My computer doesn’t turn on when the phone rings.
PowerKey Pro doesn’t answer the phone or detect tones.
My computer doesn’t shut down after it is turned on by a phone
ring.
• Make sure you’ve created Events with the appropriate
Triggers. Follow through the A Phone Startup Event ex-
ample in Chapter 3.
• Make sure the phone cables are connected as described in
Chapter 2, Connecting the Phone Cables.
• Make sure PowerKey is connected to line 1 of a standard
analog phone system. If you’re not sure what kind of
phone line you have, try plugging a standard residential
phone into it. If the phone works, PowerKey Pro should
work.
Summary of Contents for PowerKey Pro 600
