Sony XDCAM PDW-HD1500, Maintenance Manual

Page: 105 / 160

PDW-HD1500/V1 (E)
6-7
6-4. Replacing Cleaner Assembly
m
.
The Cleaner assembly requires periodic check. Refer to “5-1-3. Periodic Check/Replacement Parts List” for details.
.
To prevent the possibility of damage to the optical block assembly in the drive assembly by static electricity charged in a
human body or clothes, be sure to establish a ground before starting the service operation. (Refer to Section 1-14.)
.
The spindle motor and the actuator around the objective lens have a powerful magnet. Keep magnetic substance away
from these parts. If the magnetic force makes a screwdriver hit the actuator, the objective lens will be damaged. If a
magnetic substance comes close to these parts, their characteristics may be changed.
1. Remove the top panel assembly.
(Refer to Section 1-4-1.)
2. Remove the loader assembly.
(Refer to Section 6-3.)
3. Remove the three screws and remove the CL
base assembly.
4. Remove the diameter 1.2 polyethylene
washer and, remove the CL lever spring L
and the CL lever.
5. Remove the CL spring and remove the CL
brush.
m
.
Be careful not to deform the CL base assembly.
.
Take care so that the CL spring does not come
off.
M2
x
2
CL base assembly
CL brush
CL brush
CL lever
Dia 1.2
polyethylene
washer
CL lever spring L
CL lever spring L
CL spring
CL spring
Loader assembly
6. Rotate the deceleration gear (1) in the arrow
direction until it is stopped so that the CL
brush should not be pinched. Then, install the
CL base assembly onto the loader assembly.
7. Reinstall the removed parts by reversing
steps 1 to 5 of removal.
CL base assembly
CL brush
Loader assembly
Deceleration gear (1)