Sony XDCAM PDW-HD1500, Maintenance Manual

Page: 125 / 160

PDW-HD1500/V1 (E)
6-27
6-12-11. DR-601 Board
Removal
1. Remove the top panel assembly.
(Refer to Section 1-4-1.)
2. Detach the IF-1037 board.
(Refer to Section 6-12-8.)
3. Detach the HPR-23 board.
(Refer to steps 3 to 8 of Section 6-12-9.)
4. Remove the screw, and remove the heat plate
and the three thermal sheets.
n
If the thermal sheet remains attached on the
heat plate surface during the course of
removing the heat plate, it is not necessary to
peel the thermal sheet off the heat plate. Keep
it attached.
PSW2.6
x
6
Bottom
side
Heat plate
Thermal sheets
5. Disconnect the harness from the connector
CN100, and disconnect the flexible card
wires from the connectors CN102, CN850,
CN851, CN101 and CN1101 respectively.
n
The flexible card wires connected to CN850
and CN851 of the DR-601 board have a
conductive area on both sides, and the tip on
the reverse side is insulated. Insert the
flexible card wire into the deep end of the
connector as far as it will go, and then lock it.
6. Remove the four screws and detach the DR-
601 board
Reinstallation
1. Reinstall the removed parts by reversing
steps 1 to 6 above.
PSW2.6
x
6
DR-601 board
Flexible
card wires
Flexible card wire
CN100
harness
CN102
CN101
CN1101
CN850
CN851
Insulation side
Conduction side
Conduction side
Obverse side Reverse side