100
Transferring Clips (Direct FTP Function)
Chapt
er 5 Ope
rati
ons
in GUI
S
c
reens
To enable the UPnP function
The UPnP (universal plug and play) function allows
devices to be easily connected to networks. The following
XDCAM devices support UPnP.
• PDW-F1600
• PDW-HD1500
• PDW-HR1
• PDW-F800
• PDW-700
To enable the UPnP function on this unit, set maintenance
menu item M59: UPnP to ENABLE, and then power the
unit off and on again.
For the settings on other XDCAM devices, refer to the
operation manuals supplied with the devices.
Uploading clips
To upload entire clips
Proceed as follows to upload selected clips or all clips and
clip lists on the disc.
See page 75 for more information about thumbnail screen
operations.
1
In the clip thumbnail screen, select the clip to upload
(multiple selections possible).
To upload all clips and clip lists on the disc, start from
step
2
.
2
Display the Thumbnail Menu.
3
Select Upload Clips via Direct FTP, and then press the
PUSH SET(S.SEL) knob.
The Select Transfer Type screen of the Upload Clips
via Direct FTP command appears.
4
Select the type of clip transfer.
Selected Clips:
Clips selected in step
1
.
All Clips & ClipList:
All clips and clip lists on the
disc.
To transfer while preserving the UMID of the
transfer source clips
Check the “UMID Unchanged” option.
If the remote host is a computer, clips are transferred
with the UMID unchanged regardless of this setting.
To reconnect to a remote host
The Reconnect button is enabled if the most recent
operation successfully established a connection to a
remote host.
You can select “Reconnect” and press the PUSH
SET(S.SEL) knob to reconnect to that host. The host is
selected automatically and the screen changes directly
to the Connecting Status screen
(see step
9
in the
procedure)
.
The Reconnect button is not enabled if the most recent
operation failed to connect to a remote host.
5
Select
,
, and then press the PUSH SET(S.SEL)
knob.
The Select Remote Host screen appears.
6
Select the remote host (the target device to which you
want to transfer the clips).
You can register up to four remote hosts.
Remote Host 1 to 3:
Register these in the settings
screen.
Remote Host 4(UPnP):
A remote host that supports
UPnP (universal plug and play) is detected and
registered automatically
.
To check remote hosts discovered by the UPnP
function
Select “Hosts Discovered via UPnP”, and then press
the PUSH SET(S.SEL) knob. (If the UPnP function of
this unit is disabled, a confirmation screen appears
prompting you to enable it. Select “OK” and then press
the PUSH SET(S.SEL) knob. The UPnP function will
Note
Note
