30
GB
If the BLUETOOTH audio device is stored in
a case which interrupts the signal, remove
the audio device from the case during use.
Several BLUETOOTH devices or other
devices which emit radio waves are in use
nearby.
– Turn off the other devices.
– Increase the distance from the other
devices.
The playback sound stops momentarily
when the connection between this unit
and the cellular phone is being made. This
is not a malfunction.
The connected BLUETOOTH audio device
cannot be controlled.
Check that the connected BLUETOOTH
audio device supports AVRCP.
Some functions do not work.
Check if the connecting device supports
the functions in question.
A call is answered unintentionally.
The connecting phone is set to answer a
call automatically.
Pairing failed due to a timeout.
Depending on the connecting device, the
time limit for pairing may be short.
– Try completing the pairing within the
time.
BLUETOOTH function cannot operate.
Turn off the unit by pressing OFF for more
than 2 seconds, then turn the unit on
again.
No sound is output from the car speakers
during handsfree call.
If the sound is output from the cellular
phone, set the cellular phone to output
the sound from the car speakers.
Siri Eyes Free is not activated.
Perform the handsfree registration for an
iPhone that supports Siri Eyes Free.
Set the Siri function on the iPhone to on.
Cancel the BLUETOOTH connection with
the iPhone and the unit, and reconnect.
SongPal operation
Application name is mismatched with the
actual application in “SongPal”.
Launch the application again from the
“SongPal” application.
While running the “SongPal” application
via BLUETOOTH, the display automatically
switches to [BT AUDIO].
The “SongPal” application or BLUETOOTH
function has failed.
Run the application again.
The “SongPal” application is automatically
disconnected when the display switches
to [IPD].
The “SongPal” application on iPhone/iPod
does not support iPod playback.
– Change the source of the unit to other
than [IPD], then establish the “SongPal”
connection (page 16).
Messages
The following messages may appear or flash
during operation.
CD ERROR:
The disc cannot be played. The
disc will be ejected automatically.
Clean or insert the disc correctly, or make
sure the disc is not blank or defective.
CD NO MUSIC:
There is no playable file. The
disc will be ejected automatically.
Insert a disc containing playable files
(page 25).
CD PUSH EJT:
The disc could not be ejected
properly.
Press
(eject).
HUB NO SUPRT:
USB hubs are not
supported.
INVALID
The selected operation could be invalid.
[USB MODE] cannot be changed during
iPod playback.
IPD STOP:
iPod playback has finished.
Operate your iPod/iPhone to start
playback.
