6-83
HVR-HD1000J/HD1000U/HD1000N/HD1000E/HD1000P/HD1000C
3-10. LED Base
1
LED (D902)
3
LED base
A
F
4
Reel lock release
•
The reel lock release part must not be re-used.
•
The retainer plate must not have any deformation.
•
The reel lock release must be full engaged.
(Must not be left in the half-installed state.)
Claw
E
Claw
B
Claw
C
Claw
D
LED
Dowel
Reel lock release
LED base
Key Points
in Re-assembling
Key Points
in Re-assembling
2
Screw
(M1.4
×
1.8)
•
All claws must be fully engaged.
(Caution : No claws should be left disengaged.)
•
The flexible board should not be pinched by anything.
•
The retainer plate must not touch with the MIC terminal.
1.
Removal procedure
1) Remove the LED (D902)
1
from the LED base.
2) Remove the screw (precision screw M1.4
×
1.8)
2
.
3) Float the LED base
3
and remove the dowel.
4) Slide the LED base
3
in the direction of the arrow
A
, and
disengage the three claws at
B
,
C
and
D
.
5) While freeing the LED from the LED base
3
, remove the
LED base
3
.
6) Disengage the claw
E
and remove the Reel Lock Cancel.
2.
Attachment procedure
1) Install the Reel Lock Cancel.
2) While passing the LED (D902)
1
through the hole of the LED
base
3
, place the LED base
3
on top of the LS chassis.
3) Align the position of the LED base
3
first with the claws
B
and
C
, then slide the LED base
3
in the direction of the
arrow
F
, and engage the three claws
B
,
C
and
D
, and the
dowel.
4) Install the screw (precision screw M1.4
×
1.8)
2
.
Tightening torque: 0.04
±
0.01 N•m (0.41
±
0.1 kgf•cm)
5) Install the LED (D902)
1
to the LED base.