Sony HSR-1, Service Manual

Page: 45 / 188

1-33
HSR-1/1P HSR-2/2P
Chapter 4
Menu Operations
4-14
Chapter 4 Menu Operations
Menu Items
Display Char. display Contents
Layer 2 Layer 3 Layer 4
PARALLEL INm MENU >>>Menu
Function the same as those on the menu operation block on the
SET/YES
>>>Set/Yes front panel.
RESET/NO
>>>Reset/No
B >>>Left
b >>>Right
v
>>>Down
V
>>>Up
PARALLEL OUTPUT
>ParaOutput
For assigning a function to each output pin (8 outputs) of the
PARALLEL I/O connector on the rear panel.
OUTm (n PIN)
>>n PIN
m = 1 to 8, n = pin number 15 to 18, 33 to 36
NO USE
>>>No use
Outputs no signal.
STOP >>>Stop St Outputs status signals to indicate the operating statuses of the
recorder.
REC >>>Rec St
PLAY >>>Play St
F.FWD
>>>FFWD St
REW
>>>REW St
SERIES REC
>>>SeriesRec
Outputs the Series-recording signal.
TIME
>>>Time Set
Outputs the clock set signal when the internal clock counts 00
ADJUSTMENT minute 00 second.
ALARM >>>AlmRetrn Outputs a signal upon return from alarm recording
RETURN
ALARM >>>Alarm Outputs a status signal to indicate that alarm recording is in
progress.
TAPE END >>>Tape End Outputs a signal when tape end is reached during
recording.
TAPE EXIST >>>TapeExst Outputs a signal when a cassette is in the recorder.
ERROR >>>Error Outputs a signal when an error occurs in the recorder.
VIDEO LOSS
>>>Videolos
Outputs a signal when the video input from a camera set to
“CONNECT” is lost.
PRE END
>>>Pre-end
Outputs a signal when the tape remaining becomes less than 3
minutes based on the tape length.
PARALLEL OUT VOLTAGE
>POutVolt
For setting the output voltage from each output pin (8 outputs)
of the PARALLEL I/O connector on the rear panel.
OUTm (n PIN) >>n PIN m = 1 to 8, n = pin number 15 to 18, 33 to 36
OPEN >>>Open Outputs with OPEN/0 V.
5V >>>5V Outputs with 5 V.
12V >>>12V Outputs with 12 V.
INPUT
(continued) (n PIN)
(continued)
Chapter 4
Menu Operations
Chapter 4 Menu Operations
4-15
Maintenance Menu (Enhanced Menu)
The Maintenance Menu is an enhanced menu and is
displayed only when MENU GRADE is set to ENH on
the top menu.
Monitor Display
SETUP MENU
MAINTENANCE MENU
HOURS METER
VERSION DISPLAY
Character display
Mainte Menu
↓
Press the b key.
>HoursMeter
The Maintenance menu item selected when you left the
menu the last time is displayed.
Display Char. display Contents
Layer 2
HOURS METER
>HoursMeter
Enters the mode to check the hours meter.
For the checking procedure, see “Regular Checks” on page
6-2.
VERSION DISPLAY
>Ver Disp
Shows the software version.