Sony HDC-750A, Operation Manual

Page: 68 / 114

2-1 Accessory Attachment Points
Chapter 2 Location and Function of Parts
2-2(E)
Chapter 2 Location and Function of Parts
2-2 Controls
Right side
1
Y/RGB switch
2
R/G/B switch
3
VF DISP switch
4
CAMERA/VTR switch
5
GAIN switch
6
OUTPUT/DCC switch
7
WHITE BAL switch
8
CANCEL button
9
MENU SEL control
0
FILTER control
!¡
AUTO W/B BAL switch
1
Y/RGB switch
Selects the video signal output for the TEST OUT
connector.
Y: Output is the Y signal (this is the power-on
default)
RGB: Output is the component video signal(s)
selected by the R/G/B switch
2
.
2
R/G/B (red/green/blue) switch
When the Y/RGB switch
1
is set to RGB, selects the
component video signal(s) to be provided as output to
the TEST OUT connector.
3
VF DISP (viewfinder display) switch
Turns on or off the displays (safety zone marker,
center marker, text displays) and menu screens on the
viewfinder screen.
ON: Text describing the camera’s operation status
will be displayed on the viewfinder screen.
OFF: All viewfinder screen displays will be turned
off.
MENU: Setup menus will be displayed on the
viewfinder screen.
See “4-5 Setup Using the OPERATION Menu” on
page 4-10(E) for information on the setup menus and how to
use them.
4
CAMERA/VTR switch
Selects control signals sent to a VTR connected to the
camera. The operation of the VTR at the start of
recording for each setting is shown in the table below.
5
GAIN switch
Used to select the gain of the video amplifier based on
lighting conditions. The gain values for the L, M, and
H settings may be set using the menus. When shipped
from the factory, the values set are L = 0 dB,
M = 6 dB, and H = 12 dB.
CAMERA VTR Function
OFF SAVE Turn off the camera power.
ON SAVE Camera power is on. When the VTR’s
START button is pressed, recording will
begin after a few seconds.
ON STBY Turn on the camera power. When the
VTR’s START button is pressed,
recording will begin immediately.