![background image](http://html.mh-extra.com/html/sony/giga-juke-nas-50hde/giga-juke-nas-50hde_operating-instructions-manual_420549082.webp)
NAS-50HDE.GB.2-890-157-
11
(1)
GB
Connect the power cord.
Connect the power cord to a wall outlet
after all other connections have been made.
The unit turns on automatically and starts
making the initial settings. Wait until the
unit turns off again.
The initial settings may take a few minutes
depending on the unit’s condition.
WARNING
Do not disconnect the power cord while the
initial setup is in progress. Doing so may cause
the unit to malfunction.
To insert the batteries into the
remote control
Insert two size-AA (R6) batteries
(supplied) into the remote control with the
+ and – terminals matching the polarity
markings.
When the remote control is no longer able
to operate the unit, replace both batteries
with new ones.
To set up the AM loop antenna
1
Unroll the antenna cord from the antenna.
Antenna cord
2
Assemble the AM loop antenna so that it
stands vertically.
Unfold the stand, raise the antenna vertically,
and insert it into the slot as shown in the
figure below.
To attach the speaker pads
Attaching the supplied speaker pads to the
bottom corner of the speakers to stabilize
the speakers and to prevent them from
slipping.
To attach the optional
“WALKMAN” (ATRAC AD) stand to
the unit
For the compatible stand models, refer to
the customer support site of Sony Europe,
http://support.sony-europe.com/ (for the
customers in Europe only).
1
Connect the USB cable supplied with the
“WALKMAN” (ATRAC AD) to the USB jack on
the stand.
Stand (optional)
Connect the USB cable firmly
until it clicks.