1-22
DMW-S01NL/S02NL/ST001
1-6-2. DMW-ST001
.
Front side
.
Inside
Switch
FC address setting switch :
When several sets of the DMW-ST001 connects to the
DMW-S01NL, different address number (0 to 11) sets to
each set respectively. When one of DMW-ST001
connect to the DMW-S01NL, address number set to 0.
Factory setting
: 0
LED
Power indicator : (green)
Light up when turned on the unit
System check indicator : (umber)
Light up when some error occurs in the unit
Light up when turned on the unit only or starting up OS
of workstation before
FC unit address indicator : (green) 0 to 11
When using the several units, address number indicator is light
up which assigned by FC unit address setting switch.
Disk status indicator : 0 to 9
Upper side : (umber) Disk check indicator
Light up when some error occurs on each disk modules
Lower side : (green) Indication of disk module operating status
Light off : Disk module is not installed.
Repeat light off and blinking : Disk module is in start up of
preparation.
Blinking at fixed periods
: Increasing or decreasing of the
disk module speed
Light on : Disk module is normal operating, but no data access.
Repeat light up and blinking : Disk module is normal
operating and performing the
data access.
0
1
2
3
4
5
6
7
8
9
0
1
2
3
4
5
6
7
8
9
10
11
FC unit address indicator
Disk status indicator 0 to 9
System check indicator
Power indicator
FC unit address setting switch
1-6. Switch and jumper-pin setting and LED functions
LED
D102 (green) : CPU operating status indication
Blinking at one second period during normal operation
D103 (green) : For design testing
D104 (green) : For design testing
D201 (red)
: IC202 status indication
Normalcy light up when starting up the unit
and then light off
Connector
CN103 : Connector for CPU program writing
Factory use
6. Jog & shuttle control panel
.
CPU-314 board
Switch
S200 : Reset switch
Press this S200 when reset the CPU and their
peripheral circuit
S300 (S300-1 to S300-4) : For design testing
Use the following factory setting
Factory setting
S300-1 to S300-4 : OFF of all
LED
D300 (green) : For design testing
D301 (green) : For design testing
D302 (green) : For design testing
D303 (green) : CPU operating status indication
Blinking at one second period during normal operation
Connector
CN300 : Connector for RS232C testing
Factory use
D303
D302
D301
D300
S300
S200
CN300
