3-3
DMW-S01NL/S02NL/ST001
3. Disk module (HDD)
(1) Remove the drive fan pack and turn off the power of the unit.
(2) Unlock the key and open the front door.
(3) Remove the disk module by pressing the notch as
shown in the figure.
4. Link control card
(1) Remove the drive fan pack and turn off the power of
the unit.
(2) Pull up the lever in arrow direction of the figure and
remove the link control card toward in front.
n
When removing the link control card, confirm the DMW-
S01NL system was stopped.
Adjustment after replacing the link control card
After replacement of the link control card, setting or
adjustment etc., are not required.
LCC Card : EMC Parts No. DAELCC
LCC Card
Notch
18G Disk Module
3-2. Replacement of Main Parts
n
.
Disk module is extreme weak by shock hazard, take care to
handle it to prevent shock. Therefore, disk module is damaged
inner of it by only a very little shock in case of it places on the
table. If a worker has inexperienced of handling the disk
module, make sure not performs of replacing it to the utmost.
.
When replacing, make sure use the provided ESD wrist
band. After clip of an ESD wrist band is installed to the
metallic chassis etc., of the DMW-ST001, attach your arm in
order that metallic button of the band touches to your skin.
.
As DMW-ST001 employs leaving the disk module just as it
was removed, air conditioning is incorrect operated, it cause
of the trouble, so make sure that disk module is not re-
moved until new one come to hand.
.
When disk module is removing or inserting, make sure turn
off the power of the DMW-ST001.
When rotating the disk, be careful not to give the vibration
or shock hazard as well as not to damage it. Also do not
remove the disk module until rotation of the disk is stopped
in condition that turned off the power of the DMW-ST001.
(Wait for one minute or more until rotating is stopped.)
.
Do not apply the power to the DMW-ST001 leaving the
front door just as it was opened. Make sure close the front
door after completed the replacement that it was opened
temporarily for replacement of the disk module.
Adjustment after replacing the disk module
After replacement of the disk module, performs the remaking
of the logical drive using disk utility. (Refer to Sec. 5-6-5, 2)
18GB Disk Module : EMC Parts No. SONY18