2-31
DMW-S01NL/S02NL/ST001
2-5-3.
Replacement of Main Parts
1. Replacement of electromagnetic clutch
assembly
Required tool
L-shaped hex.wrench
(Width across flat = 3 mm) : 7-721-140-60
(1) Remove five screws (BVTP3
x
8) and remove the
device control panel (upper) assembly. (Refer to
section 2-5-2.)
(2) Disconnect the harness from the connector (CN1) on
the DET-11 board.
(3) Remove three screws (BVTP3
x
8) and remove the
search dial assembly.
2. Device Control Panel (Lower)
(1) Remove the device control panel (top) assembly, then
disconnect the flat cable from the connector (CN400)
on the CPU-314 board. (Refer to steps (1) and (2) in
section 2-5-2-1.)
(2) Remove three screws (PSW3
x
8 : 2 pieces,
BVTP3
x
8 : 1 piece) and remove the shield plate
(upper).
(3) Remove five screws (BVTP 3
x
8 : 4 pieces, PSW 3
x
6
: 1 piece), then remove the CPU-314 board, shield
plate (lower) and reinforcement.
(4) Remove two screws (B3
x
6) and remove the rear
panel.
B3
x
6
BVTP3
x
8
PSW3
x
8
(4-382-854-01)
BVTP3
x
8
BVTP3
x
8
Shield plate (upper)
Rear panel
Device control
panel (lower)
CPU-314
board
Shield plate (lower)
PSW3
x
6
Reinforcement
Shield plate (lower)
BVTP3
x
8
DET-11 board
Harness
CN1
Search dial
assembly
Device control panel (top) assembly
n
When disconnecting/re-connecting the flat cable, be
careful not to damage it.
2-5. Jog & Shuttle Control Panel