S0 User Handbook
23
C
ONFIGUR
A
TION OPTIONS
CO N F I G U R AT I O N O P T I O N S
3
Page 4 – Remote Output Modes (LED on PPM Scale 4)
Remote Output Modes are set using the START buttons on channels 1-8 and the LINE HOLD
button on channel 9. The Remote output modes are set independently for all inputs on each
channel. The input select buttons on each channel select which input the remote mode
is assigned to. A channel is considered active when either PGM or REC is selected and the
fader is open.
Mode 1
Latching remote start when channel or LINE HOLD is active. Latching remote
stop when channel or LINE HOLD is inactive.
Mode 2
Momentary remote start for 0.5 seconds when the channel becomes active.
Additional momentary remote starts, for 0.5 seconds each, can be activated
by pressing the START button. Momentary remote stop for 0.5 seconds when the
channel becomes inactive.
Mode 3
Momentary remote start for 0.5 seconds when the channel becomes active.
Repeat start is disabled. Momentary remote stop for 0.5 seconds when the
channel becomes inactive.
Mode 4
The remote outputs are disabled.
Mode 5
Remotes and START button states are set by USB Serial commands.
Mode 6
Latching remote start when LINE HOLD is active, telephone line ringing indicated
on remote stop. Available for selection on channel 9 TEL mode only.
Defaults: Channels 1-4
MIC
Mode 1
LINE
Mode 2
Channels 5-8
INP1
Mode 2
INP2
Mode
2
USB Audio Mode 2
Channel 9
TEL
Mode 6
AUX Rear
Mode 2
AUX Front
Mode 2
The CUE/PFL buttons are used to set whether the remotes are active when CUE/PFL is
activated and deactivated or not.
Mode 1
Remotes are active when CUE/PFL is activated/deactivated (default).
Mode 2
Remotes are not active when CUE/PFL is activated/deactivated.
