S0 User Handbook
5
INTRODUC
TION
I N T R O D U C T I O N
1
Configuration Settings
The S0 has a range of software configurable options which can be used to customize the
operation of the mixer. It is possible to enable or disable specific inputs, enable phantom
power for the microphone channels and limit which buses each channel can be routed to.
Other settings control auto cancelling of PRE FADE when the channel fader is opened and all
the remote output configurations.
The S0 has an integral universal switch mode power supply, which uses an IEC mains inlet.
Installation Notes
Atmosphere
The S0 mixer should be installed in an area which is not subject to excessive heat or cold.
Also, you should avoid installing it in atmospheric conditions which are dusty, smoky or
dirty, or where there is moisture or vibration. Do not use any liquids to clean the fascia of the
mixer: a soft dry brush is ideal. Use a clean cloth moistened with water or ethyl alcohol to
clean the trim. Other solvents may cause damage to paint or plastic parts.
Electromagnetic Radiation
Avoid using the S0 mixer close to strong sources of electromagnetic radiation such as, video
monitors or high power electric cabling. This may cause degradation of the audio quality
due to induced voltages in connecting leads and chassis. In all cases the S0 mixer should be
installed and serviced by qualified personnel.
Dimensions and Cut-Out Size for Flush Mounting
External dimensions: 483mm (W) x 356mm (D) x 125mm (H)
The cut-out size is for reference only and should be checked with your mixer.
Fig 1-2: S0 Mixer - Cut-out Sizes.
345mm
440mm
