8
S0 User Handbook
U S E R G U I D E
USER GUIDE
2
and adjusted via the TRIM control, and the pan or balance can be set
with the PAN/BAL control. Provided that the fader is closed, the signal
will not be routed to the PGM or REC outputs even if they are selected.
This button is illuminated green to indicate CUE PFL is active and it
has a momentary and latched action: if the button is held down, CUE
PFL is cancelled when released. There is a Configuration Option to
automatically cancel CUE PFL when the fader is opened. This option is
enabled by default.
FADER Control
The 100mm VCA fader is a linear level control that operates between fully
attenuated in its lowest position to unity gain when fully open.
START Button
This button has a different function depending on whether MIC or LINE
is selected. When in MIC mode, the button is an indicator and shows the
state of the channel and the remote output as follows:
Off
The channel is not routed to either the PGM or
REC
bus.
Illuminated Red
The channel is routed to the PGM or REC bus,
the fader is closed and the remote stop output
is
enabled.
Illuminated Green
The channel is routed to the PGM or REC bus,
the fader is open and the remote start output
is
enabled.
This is the default operation when in MIC mode, but this can be changed
in the Configuration Options.
When in LINE mode, the button indicates the state of the channel, and
also controls the operation of the remote outputs as follows:
Off
The remote outputs are disabled. Pressing the button will enable/
disable the remote outputs, but they can only be disabled when the
fader is closed.
Flashing Red
The remote outputs are enabled, but the channel is not currently
routed to the PGM or REC bus so the remote start and stop outputs
are
inactive.
Illuminated Red
The remote outputs are enabled, the channel is routed to the PGM
or REC bus and the fader is closed. If the fader is opened, the remote
start output will become active and give a momentary pulse for
0.5
seconds.
Illuminated Green
The remote outputs are enabled, the channel is routed to the PGM
or REC bus and the fader is open. If the button is pressed, the remote
Fig 2-4: Channel 1
FADER Control &
START Button.
