S0 User Handbook
13
USER GUIDE
U S E R G U I D E
2
CUE/PFL & TB Button
Selecting CUE/PFL & TB routes the pre-fader input signal to the monitoring
section where the signal can be heard on the Monitor, Presenter or Guest
headphones provided the associated AUTO CUE/PFL button is selected.
The level can then be checked on the meters and adjusted via the TRIM
control, and the pan or balance set with the PAN/BAL control. When the
channel is in TEL mode, selecting CUE/PFL & TB also enables talkback from
the channel 1 microphone to the caller on the telephone, without having
to open the fader on channel 1. Provided the fader is closed, the signal will
not be routed to the PGM or REC outputs even if they are selected. This
button is illuminated green to indicate CUE/PFL & TB is active, and it has a
momentary and latched action; if the button is held down, CUE/PFL & TB is
cancelled when released. There is a Configuration Option to automatically
cancel CUE/PFL & TB when the fader is opened. This option is enabled by
default.
FADER Control
The 100mm VCA fader is a linear level control that operates between fully
attenuated in its lowest position to unity gain when fully open.
LINE HOLD Button
This button has a different function depending on whether TEL or AUX is
selected. When in TEL mode, the button controls the connection to the
telephone line and indicates the state of the connection as follows:
Off
The telephone line is disconnected. The remote
stop output is active. Pressing the button will connect
the channel to the telephone line.
Flashing Red
The channel is connected to the telephone line, but
it is not currently routed to the PGM or REC bus.
The remote start output is active. Pressing the button
will disconnect the channel from the telephone line.
Illuminated Red
The channel is connected to the telephone line and it
is routed to the PGM or REC bus. The remote start
output is active. Pressing the button will disconnect
the channel from the telephone line.
Pulsing Red
This indicates that the telephone line is ringing.
Pressing the button will connect the channel to the
telephone line and pick up the call.
This is the default operation when in TEL mode, but this can be changed in
the Configuration Options.
Fig 2-11: CUE/
PFL, Fader & LINE/
HOLD Button.
