13
User Guide 2
FADER Control
The 100mm VCA fader is a linear level control that operates between fully
attenuated in its lowest position to unity gain when fully open.
LINE HOLD Button
This button has a different function depending on whether TEL or AUX is
selected. When in TEL mode, the button controls the connection to the
telephone line and indicates the state of the connection as follows:
Off
The telephone line is disconnected. The remote
stop output is active. Pressing the button will connect
the channel to the telephone line.
Flashing Red
The channel is connected to the telephone line, but
it is not currently routed to the PGM or REC bus.
The remote start output is active. Pressing the button
will disconnect the channel from the telephone line.
Illuminated Red
The channel is connected to the telephone line and it
is routed to the PGM or REC bus. The remote start
output is active. Pressing the button will disconnect
the channel from the telephone line.
Pulsing Red
This indicates that the telephone line is ringing.
Pressing the button will connect the channel to the
telephone line and pick up the call.
This is the default operation when in TEL mode, but this can be changed in
the Configuration Options.
When in AUX mode, the button indicates the state of the channel, and also
controls the operation of the remote outputs as follows:
Off
The remote outputs as disabled. Pressing the button
will enable/disable the remote outputs, but they can
only be disabled when the fader is closed.
Flashing Red
The remote outputs are enabled, but the channel is
not currently routed to the PGM or REC bus so the
remote start and stop outputs are inactive.
Illuminated Red
The remote outputs are enabled, the channel is
routed to the PGM or REC bus and the fader is closed.
If the fader is opened, the remote start output will
become active and give a momentary pulse for
0.5 seconds.
Illuminated Green
The remote outputs are enabled, the channel is
routed to the PGM or REC bus and the fader is open.
If the button is pressed, the remote start output will
become active and give a momentary pulse for
0.5 seconds. If the fader is closed, the remote stop
will become active and give a momentary pulse for
0.5 seconds.
This is the default operation when in AUX mode,
but this can be changed in the Configuration Options.
Main Outputs
The S0 v2 has 2 main outputs mounted on the rear
panel.
PROGRAM OUTPUT
This is the main mixing desk output which would
normally be connected to the transmission or
encoding system. All input channels that have the
PGM bus selected and the fader open will be mixed
onto this stereo balanced XLR output.
Fig 2-13: Mains
Outputs.
