™
5(20)
© Soneco Oy.
V 23.7.2013
Staus: Contents schecked
Author: JR
Quick procedure for using the device for the first time
1. Switch ON the power by pressing the button (for over 5 seconds) until the
yellow light starts to blink. Release the button.
2. If the device has not been programmed before, it enters to the
programming mode automatically and the YELLOW and the GREEN
lights start blinking alternately. If the device has already been
programmed, the programming mode can be triggered by pressing the
button after the YELLOW light stops blinking and the GREEN light is on
for 5 seconds.
3. Program the telephone numbers and if necessary, optional settings and
user specific message with sending programming text messages to the
device.
4. In order to exit the programming mode, press the button shortly and
release it. In order to check the programmed data, pressing the button for
longer than 5 seconds will cause the settings to be sent as a text
message (SMS) to the first stored number if given.
5. Wait until the device switches the power OFF. The power is OFF when all
the lights flash once. You can re-start the device.
6. When the device has entered the standby mode, the GREEN light
flashes in 2 seconds interval.
7. In order to switch the power OFF, press the button (for over 5 seconds)
until all lights turn on. Then release the button. CC3 switches OFF. If
switch-off by the user is blocked, see Chapter 12.
8. Please remember to charge the battery as instructed.