™
13(20)
© Soneco Oy.
V 23.7.2013
Staus: Contents schecked
Author: JR
A failure to make a call should be very rare and should not occur without a reason,
such as over-load in the network, operation in the boundary areas of network
coverage, or weak radio signal inside a massive building, or a defective device.
10.2. Receiving and terminating of the calls
The device indicates an incoming call with a melodic ringing tone at the volume set
by the user, and with alternating blinking of all lights. Ringing tone may be switched
off so that only light indication appears.
An incoming call is responded with a short press of the button. A long press rejects
the call.
If automatic answering has been activated, the call is answered after the third
ringing tone.
The device may have been set to reject other calls than calls from stored numbers.
Such cases are not indicated at all.
A call is terminated with a short press of the button. If the other party terminates the
call first, the connection with the device is terminated also automatically.
10.3. Receiving and terminating of the calling efforts
When the calling engine is making efforts to set up a call, the device directs the call
to such a stored number that first sends any message to the device, and terminates
the further operation of the calling engine.
The user can terminate the calling efforts with a short press of the button.
10.4. Adjusting the features of the voice call
Prior to a call in standby mode or alarm mode, the audio volume in earpiece can be
adjusted with a V-command, the sensitivity of the microphone adjusted with G-
command and the level of the ringing tone with I-command with the exception that a
silent call in alarm mode remains silent. As an example, the command
"<<<V2G6I5>>>" set earpiece volume level 2, the microphone sensitivity to level 6
and the ringing volume level 5. The adjustments made in standby mode apply for
the next call after which the programmed settings apply.
In most versions the sound level of the earpiece can be adjusted also during the call
by sending the V-command during the call.
11. Special features during alarm mode
CC3 is in alarm mode only when it is trying to make a call.
During this mode the call can be directed to the stored number that sends a
message to the device. This mode can be terminated with a press of the button
after which the device returns to the standby mode.
