™
14(20)
© Soneco Oy.
V 23.7.2013
Staus: Contents schecked
Author: JR
12. Shutting the device off
When allowed, the user can switch off the device with pressing the button for over 5
seconds, until alls lights switch on, and releasing it before 10 seconds. The device
gives an audible signal and shuts down the lights one by one. Shut-off is completed
when all lights flash once.
If shutting the power-off has been inhibited, the device can be shut off via LIMITED
mode. Remove the SIM as seen in Fig. 1 and wait until the device tries a new start-
up, indicates a SIM error and enters the LIMITED mode wit continuously blinking
RED. Press the button as above, i.e. for 5 seconds. The device shuts off.
13. Request for battery charge status
The device reports the battery status in standby mode as a reply to the message
<<<battery>>>
. The message has to be sent from a number that is stored in the
device. The device responds to the same number with a message containing
estimated remaining battery capacity in %, battery voltage in mV and the
information about whether a charger is connected and a call ongoing.
14. Voice call features in alarm state
This applies only to MC3. If CC3 is re-programmed in to MC3, please refer to User's
Guide for MC3.
15. Emergency call 112
The MC3 device can be set to allow emergency 112 calls in standby mode.
If emergency calls in standby mode are not in use, the device will shut off after
pressing the button for 5 seconds or if shutting-off is not allowed, the device sends
an alarm.
If emergency calls are enabled, pressing the button continuously for 10 seconds
causes that all lights go on at 5 seconds and an audible signal at 10 seconds.
Releasing the button at this point would shut the device off if allowed, or send the
alarm message if shut-off is blocked. With continuing the pressing beyond this point
the device gives two short audible signals and flashes all lights three times.
Continuing to press also beyond this point will trigger an emergency call. This is
indicated by the RED light. Accordingly, releasing the button at this stage will return
the device to standby mode.
A triggered emergency call can be terminated with pressing the button again.
In the LIMITED mode a long press beyond 10 seconds will always trigger the
emergency call as above.
A simplified, easy to remember emergency call instruction: press the button until the
RED light is continuously on. Pressing the button after this or releasing it has no
effect. Pressing the button again will terminate the emergency call.
