- 18 -
4.2.3 Manual Start
Connect the sensors to the patient and switch on the
SOMNOscreen™ plus
.
Please Note:
The
SOMNOscreen™ plus should only be turned on after the patient has been fully set up. The
on button is found on the second
“O” of the word SOMNOscreen™ plus.
Press the red arrow 4 times in order to manually start the recording.
Fig. 4-6: Manual Start
→
A successful Start will be indicated by
“01. Recording…” on the display!
After the recording the device turns itself off automatically.
4.2.4
Programmed Start without signal check on Display
Connect the sensors to the Patient and Switch on the
SOMNOscreen™ plus
.
Please Note:
The
SOMNOscreen™ plus should only be turned on after the patient has been fully set up. The
on button is found on the second “O” of the word SOMNOscreen™ plus.
If using the
Auto Start Without Signal Check on Display
, the
SOMNOscreen™ plus automatically
changes to waiting mode after being switched on.
...when the start
time is reached...
The device carries out a system check and checks all settings. In the event that
there is insufficient battery capacity or storage space on the Compact Flash
Card see chapter 4.2.9.
The waiting mode is activated automatically (the status LED blinks) until the
pre-programmed start time is reached.
It is possible to interrupt the waiting mode by pushing S4 button
O
for at least 5
seconds to cancel the recording.
When the Start Time is reached, the recording will start automatically.
→
Successful start will be shown on the display as “01. Recording…”!
The device switches off automatically after the recording is completed.
