- 19 -
4.2.5
Auto Start with Prior Signal Check
Connect the sensors to the patient and switch on the
SOMNOscreen™ plus
.
Please Note:
The
SOMNOscreen™ plus should only be turned on after the patient has been fully set up. The
on button is found on the second “O” of the word SOMNOscreen™ plus.
The ID (last name of patient) will be shown on the display.
To check the signals, select the
Menu
button on the display and confirm using
S3
.
Select the
Signals
menu and confirm using S3
.
The display will show the number of channels as set in the Montage as well as
the required storage capacity per hour. To check the signals, select
Display
.
On the top left of the display the name of the first signal appears. To view the
detailed signal on the screen select
Display
with key S3
. You may close
and exit the Signal Display Mode at any time using the
Back
button.
You will be returned to the
Main Menu
and can now start the recording by
selecting
Record
and confirming it with S3
.
Select
OK
and confirm with S3
.
Select
OK
and confirm with S3
.
Select
START
and confirm with S3
.
The device will execute a
System
and
parameter
check.
when start time is
reached..
The waiting mode is activated and the status LED blinks until the pre-
programmed start time is reached.
It is possible to interrupt the waiting mode by pushing S4 button
O
for at least 5
seconds to cancel the recording.
When the Start Time is reached, the recording will start automatically.
→
Successful start will be shown on the display as “01. Recording…”!
The device switches off automatically after the recording is completed.
