9
Copyright © 2013 Somfy SAS. All rights reserved.
Video door phone - V600 RTS
EN
SETTINg ThE fINgERpRINT SCaNNER paRamETERS
Important:
To set the parameters for the door station fingerprint scanner, place the adjustment remote control supplied with the video entry
system opposite the door station infrared cell (no. 5, page 4).
*
3
+
+
x x x x
x x x x
x x x
vert
#
3 sec
Code administrateur
=
1 2 3 4
→
Changing the administrator code
[1].
Switch to programming mode.
[2].
Press
*
(star) then 3 on the adjustment remote control.
The indicator light above the scanner flashes yellow.
[3].
Enter your new 4-figure code.
[4].
Enter your new 4-figure code again
The door station emits a beep to confirm. The administrator code has
been changed.
→
Forgotten administrator code
[1].
Turn off the door station power supply, then switch the power on again.
[2].
Within 5 seconds of switching the power supply back on, press # on the
adjustment remote control for 3 seconds.
The door station emits a beep to confirm. The default administrator code
of 1234 is restored.
► Storing a fingerprint
Every stored fingerprint is identified by a number which you have allocated
it. Fingerprints can be numbered from 000 to 899.
[1].
Switch to programming mode.
[2].
Enter a 3-figure fingerprint identification number on the adjustment
remote control (for example, 001).
- If the indicator light above the scanner turns green, this fingerprinting
number is available. Carry out step [3].
- If the indicator light above the scanner turns red, this fingerprint
number is already in use. Enter another fingerprint number.
[3].
Ask the person whose fingerprint you wish to store to place their finger
on the fingerprint scanner.
Important:
Do not slide your finger over the fingerprint scanner. You just
need to place it on the scanner.
- The door station emits 2 short beeps and then a long one. The
fingerprint is stored.
- If the door station emits one beep, then 3 beeps, the fingerprint has
not been correctly scanned. Place your finger back on the scanner
again to store its print.
- If the door station emits one beep, then 4 beeps, the fingerprint is
already stored.
new
administrator
code
administrator
code
new
administrator
code
administrator
code
administrator code
fingerprint no.
green
+
x x x x
x x x x
yellow
yellow
red
Switching to programming mode
When the indicator light above the scanner lights up red, enter the
administration code twice (default 1234) on the adjustment remote
control.
The indicator turns yellow.
possible parameter settings
►
administrator code
The administrator code allows entry to the fingerprint scanner's adjustment mode. The default administrator code is 1234.