15
Copyright © 2013 Somfy SAS. All rights reserved.
Video door phone - V600 RTS
EN
►
programming a Somfy RTS gate motorisation
Note:
The monitor can be disconnected from the power supply to carry out this operation.
[1].
Access the motorisation electronics.
[2].
Check that the motor is powered on.
[3].
Remove the monitor from its mounting bracket.
Select a free channel by pressing the channel selection button on the monitor.
[4].
On an Axovia 220B or an Elixo Optimo: place the monitor on the target on the motor electronic unit.
Important:
The right-hand section of the monitor must be placed on the electronic unit target so that the monitor can be correctly detected
by the motor electronics.
On an Elixo 800/1300/2000, an Elixo 500 230V RTS, an Elixo 500 3S RTS or a Control Box 3S RTS, press the PROG button for 2 seconds.
[5].
Briefly press the monitor opening button.
Note:
To program the monitor on a motorisation other than those described above, refer to the guide for this motorisation.
1 2 3 4
1 2 3 4
1 2 3 4
RADIO
RESET
=
=
RADIO
RESET
=
=
< 0,5s
AXOVIA 220B RTS
ELIXO OPTIMO RTS
ELIXO 800/1300/2000 RTS
CONTROL BOX 3S RTS
ELIXO 500 3S RTS
PROG
2s
PROG
PROG
PROG
PROG
< 0,5s
2s
Add
< 0,5s
ELIXO 500 230V RTS
1 2 3 4
1 2 3 4
1 2 3 4
RADIO
RESET
=
=
RADIO
RESET
=
=
< 0,5s
AXOVIA 220B RTS
ELIXO OPTIMO RTS
ELIXO 800/1300/2000 RTS
CONTROL BOX 3S RTS
ELIXO 500 3S RTS
PROG
2s
PROG
PROG
PROG
PROG
< 0,5s
2s
Add
< 0,5s
ELIXO 500 230V RTS
4
5
6
Note:
To clear the video entry phone programming on a Somfy gate motorisation, see the motorisation guide.
