SOMFY Elixo 500 3S RTS, Installation Instructions Manual

Page: 11 / 88

EN
Elixo 500 3S RTS
Copyright © 2015 Somfy SAS. All rights reserved
9
QUICK COMMISSIONING
Memorising the Keygo RTS remote controls for operation in complete opening mode
[1]. Press and hold the " PROG " button (2 s).
The screen displays " F0 ".
[2]. Press the button of the remote control that will open the gate fully.
The screen displays " Add ".
It is possible to store up to 40 command channels.
If this procedure is carried out using a channel which has already been memorised,
this channel will be cleared.
2 s
H0 H0 F0 Add
Self-learning
6HOIOHDUQLQJDOORZVWKHJDWHVVSHHGPD[WRUTXHDQGVORZGRZQ]RQHVWREHDGMXVWHG
- Self-learning the gate's travel is essential when commissioning the motor.
- The gate must be in the intermediate position before self-learning starts.
- During self-learning, the obstacle detection function is not active. Remove any objects or obstacles
and do not allow any persons near or inside the operating range of the motorisation.
- To carry out an emergency stop during self-learning, use a stored remote control or press one of the interface buttons.
Start self-learning
[1]. Press and hold the " SET " button (2 s).
Release the button when the screen displays " H1 ".
[2]. Press " OK " to start self-learning.
Self-learning must start with the gate being opened.
The gate performs two complete Opening and Closing cycles.
6HOIOHDUQLQJFRUUHFW
6HOIOHDUQLQJLQFRUUHFW
2 s
H0 H1
H2
H4
H2
H4
H0
C1
[1] [2]
2 s
...
...
‡
If self-learning starts when the gate is closed, stop the self-learning in progress
(press a control button: motor electronics, memorised remote control, wired
control point, etc.), move the slide as shown opposite, then restart self-learning.
‡
If self-learning is correct, the display indicates " C1 ".
‡
If self-learning has not completed correctly, the display indicates " H0 ".
At the end of installation, it must be checked that the limitation of forces complies with appendix A of the standard EN 12 453.