8. QUICK COMMISSIONING
8.1. Storing the remote controls
The remote controls can be stored for full opening and pedestrian opening
of the gate:
• pressing the programmed button for full opening causes the 2 gate
leaves to open fully,
• pressing the programmed button for pedestrian opening causes one
gate leaf to open for pedestrian access.
Attention
It is not possible to store more than 16 transmitters. Delete all the
remote controls and resume programming.
8.2. Selecting the remote control buttons
Any of the remote control buttons can be programmed to control full open-
ing of the 2 gate leaves.
If activated, the following button can be used to open the a gate leaf in
pedestrian mode.
Attention
Button 1 can only be programmed for full opening. This button
cannot be programmed for pedestrian opening.
2 touches
4 touches
ou
ou
ou
ou
Ouverture
Totale
Ouverture
Piétonne
(si activée)
Libre
1
1
2
2
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
2 buttons
4 buttons
or
or
or
or
Complete
opening
Free
Pedestrian opening
(if activated)
8.3. To store a remote control for full opening
1)
Position the remote control on the target engraved on the cover.
2)
Briefly press the button on the remote control that will open the gate fully.
The RADIO indicator light comes on then goes out when the button is
released. The button has been stored.
8.4. To activate pedestrian opening on one button
1)
Position the remote control on the target engraved on the cover.
2)
Briefly press the button on the remote control to
be activated to open the gate in pedestrian mode.
The RADIO and
indicator lights come on then go out when the
button is released. Pedestrian opening is activated on this button.
=
=
RESET
RADIO
8.5. Gate travel self-learning
Attention
Auto-programming the gate's travel is essential when commis-
sioning the motor.
The gate must be closed before auto programming is started and at
least one remote control must have been programmed.
Auto-programming consists of making the gate perform two gate leaf
opening and closing cycles.
1)
Move the remote control away from the receiver.
2)
Press the programmed button to open the gate fully. The gate opens
at reduced speed.
Attention
If the gate does not open, or moves in the direction of closing,
check the motor wiring: see “7.2. Connecting the motors”.
3)
Once both leaves of the gate are fully open, press the programmed
button on the remote control again. The gate closes, one gate leaf at
a time.
9
Copyright© 2017 SOMFY ACTIVITES SA. All rights reserved.
EN
Axovia 220B RTS
