Installation
14
EN
- EXAVIA installation and operating guide - SOMFY
EN
1
Securing the pillar mounting bracket
1
2
Secure the mounting bracket to the pillar with hardware adapted
to the mounting support.
Check that the bracket is at the right level. Retighten if necessary.
Check before proceeding to the next step
Have you checked that the brackets are perfectly horizontal on the cylinders?
1.3 Fastening the motors
Checking the position of the knob
1
2
The cylinder knob must be inside the marking, as shown in the
illustration above.
If the knob is not inside the marking, open the flap at the end
of the cylinder and turn then tighten to bring the knob to the
correct position.
Moving the opening stop
1
2
Do not remove the screws
from the stop.
Loosen the screws of the opening stop with a 10 mm offset wrench.
Move the opening stop towards the end of the
cylinder on the cable side as illustrated above.
