Solwise SAR715PVW ADSL Ethernet Router User’s Guide
Chapter
2
. Connecting to your network and line
13
2 Connecting to your network and line
LAN ports LAN1 to LAN4 on the SAR715PVW router are the type
designed to be connected directly to the port on a PC LAN card or
to any type of switch/hub port (i.e. either ‘normal’ or ‘uplink’) using a
standard cat5 LAN cable.
Use the supplied RJ11 phone cable to connect from the ADSL
socket on your router to your ADSL phone socket.
Connect the power jack from the power supply to the power socket
on the router and then plug the power supply into a suitable UK
power socket: The green POWER LED on the front of the router
should light up.
If you want to do configuration via the Command Line Interface
using Telnet then you
can
connect using the standard user name
‘admin’ and password ‘admin’ and the default IP address of the
router is 192.168.0.1. If you want to use CLI mode via the serial port
then you’ll need to connect a 9pin serial cable to the RS232
connector on the back of the router (a ‘normal’ modem, serial cable
is required which can be purchased from your supplier if needed).
Port settings are 9600,8,1,n,no flowcontrol.
