Set the incoming stream as
“Pull(BRTP)”
since the IP
address of coder is unknown. In the field URL enter the
IP of the transmitter plant (decoder) and the same port
number assigned to decoder.
In a full-duplex link, both units must work with the same
audio format.
MPEG are NOT SUPPORTED for full-
duplex mode.
ADA102 at the Transmitter Plant
At the Transmitter Plant ADA102 receives the
streaming
from Studios.
Set
“Outgoing stream”
as
“Pull(BRTP)”
since is the
coder from studios who starts the connection. IP
address is zero and the Port number mus be the used
in the section “Incoming stream” in Studios.
Set
“Incoming stream”
as
“Push(RTP)”
with IP address
zero, since the coder starts the connection to the
decoder.
2.3.3 Link with repeaters
In this mode the coder send streaming to several
devices simultaneously. This configuration is common
when you have a static IP to the
“multicast”
group and
requires a half-duplex link. In both Studio ans in Plant,
ADA102 is set as “Multicast”
(Configuration → Basic
settings → Stream Method).
Multicast is a protocol designed for maximum
efficiency of the networks when required
simultaneous transmission from one point to multiple
destinations. Both the transmitter and receiver use
the same IP address, which should be in a special
range of IP addresses for a multicast. This range
includes addresses from 224.0.0.0 to
239.255.255.255.
To implement this scheme, see your network
administrator, because you need to configure the
multicast routers.
ADA102 at the Studios
In this case ADA102 coder transmit to a multicast IP
address. Coder works in mode “Multicast”
(Configuration → Stream Method)
.
ADA102 at the Transmitter Plant
The decoder also works as “Multicast”. In the field URL
you must define the same multicast IP used in the coder.
SOLIDYNE
ADA102 CODER/DECODER
Page 17
Summary of Contents for ADA102
Page 1: ......
Page 2: ......
Page 10: ...SOLIDYNE ADA102 CODER DECODER Page 10...
