Solidyne ADA102, Owner'S Manual

Page: 7 / 20

1.3 Frontal panel
1.3.1 Level indicators
ADA102 has two needle-type VU meters that shows
the real peak value of audio signal.
1.3.1.1 VU mode Tx/Rx
This button changes the signal that the VU shows.
Tx shows the level of the analogue input. Adjusting
the input level you are adjusting the transmission
level. This is the usual work mode in the Studios.
Rx shows the output level of analogue output and
streaming. This is the usual work mode in the
Transmitter Plant.
Level indicators do not work with AES-3 signals.
1.3.2 SATUS LED's
During the initial boot up sequence the 2 status indicator
LEDs can indicate the following anomalies:
No Application loaded (only bootloader) or started
with hold reset button during power up: The green
LED is on and the red LED blinks.
Application starts (boot-up sequence):
First the red goes on and the green LED blinks once.
Then during the startup the green and red LEDs
blink.
During DHCP the red LED blinks with a continuous
cycle . The green LED blinks five times and then
pause four times.
If an error is detected the red led remains on and the
device resets itself after the green LED has indicated
the error as follows:
ERROR Green LED blinks
Corrupt application or IP address conflict five times
The Network hardware could not be initialized
or a Corrupt MAC address
three times
In normal conditions:
Green LED Red LED State
OFF BLINKING
Application is detecting USB devices or
announcing the assigned IP address
using SonicIP technology.
ON OFF The application is operational.
ON ON
Reset Button is being pressed, the unit
will reboot after releasing the button.
1.3.3 Headphones output
Gives the output signal with headphones level, to
monitoring. The level changes with the output level
control.
1.3.4 Input Gain
Manages the input gain of the analog inputs. Adjust this
level to reach 0 VU with signal peaks. To see the input
level the VU meter must be in Tx mode.
1.3.5 Output Gain
Manages the analog output level. At 0 VU the output
level is +4 dBm. To see the output level the VU meter
must be settled as Rx from rear panel.
SOLIDYNE ADA102 CODER/DECODER Page 7
Level indicators
Shows the input level (coder mode) or the output
level (decoder mode).
Input gain
(analogue)
Output gain
STATE
VU MODE
Headphones