www.soarnex.com
Power Over Ethernet Table
Power Over Ethernet Table
Port
Port:
Display each ports number.
Admin
Click pull-down list to
Enable
or
Disable
PoE function on the
port. By default, the PoE is Enabled on all PoE ports.
Status
Display current status if a PD device is connected to the PoE
port, the status is
POWER ON
or
POWER OFF
.
If no PD is connected to the PoE port, the Status is POWER OFF.
Priority
There are three types of Priority which can be selected: High,
Normal and Low.
High:
This is the highest priority level. If the port sets to High level
then it is guaranteed to receive power before any of the ports
assigned to the other priority levels.
Normal:
If the port sets to the Normal level then the PD receives power
only after all other ports assigned to the High level which is
already receiving power by this EWC wireless controller (e.g.
EWC-100-62W). By default, all EWC PoE ports are assigned to
Normal priority.
Low:
This is the lowest priority level. If the port sets to the Low level
then the PD receives power only after all other ports assigned
to High level and Normal levels are already receiving power by
Switch.
Schedule
Select the PoE Schedule configured from Management -> PoE
Scheduling page to create the Time Base PoE schedule function
on designated port(s).
Power (mW)
Display the Power in milliwatts (mW) that the PoE port is
supplying power to the PD.
Voltage (v)
Display the Voltage (v) in volts as measured at the PoE port
when the port is supplying power to PD.
Current (mA)
Display current in milliamps (mA) that the PoE port is supplying
to the PD.
Action
If user has changed any parameters, he needs to click Apply
button to apply all the changes.
