82
|
Quick Start Guide
|
83
CNC Carving
5.1.2 Initial Setup
Guides & Pictures
/ Snapmaker
Plug the AC Power Cable into an electrical outlet. Switch the power on and follow the prompts on the
Touchscreen: Read the Terms -> Name the Machine -> Connect to a Wi-Fi Network.
It is recommended to wait for 5 seconds after you restart your machine.
Skip this step if you have
completed the initial setup.
If you need to change the
settings above, swipe left
on the homepage of the
Touchscreen -> select
Settings
-> tap
Wi-Fi
or
About Machine
as needed.
The initial guide, which
helps you get started, will
appear only once. If you
need to launch it again,
swipe left on the homepage
of the Touchscreen -> select
Settings
-> tap
Guides
.
5.2.1 Fasten the Material
1. Place the provided material on the center of the CNC Carving Platform.
2. Attach the clamp set to the CNC Carving Platform, and then fasten the material by screwing the wing nuts.
Guides & Pictures
/ Snapmaker
M4 x 70 Screw
Wing Nut
Fixture Accessory
Arched Fixture
The size of our provided model is 139.2 x 141.5 mm. Make sure the clamp set does not
impede the movement of the CNC Bit.
