56
|
Quick Start Guide
|
57
3D Printing
After receiving the G-code file, tap
Disconnect
on the Touchscreen. Then
find and select the received G-code
file, and tap
Start
to start printing.
The first layer of the print is key to
print success. To prevent damage we
recommend that you keep an eye on
your print, especially while the first
layer is being laid out.
If you need to adjust
settings, you can either
tap
Adjust Settings
prior to printing or swipe
left on the printing
progress screen.
3.3.2 Start Your First Print
Guides & Pictures
/ Snapmaker
If poor adhesion occurs, swipe left on the printing progress screen and try adjusting the Z Offset. Or you can
try leveling the Heated Bed again by selecting
Calibration
. Make sure the tip of the nozzle is clean before you
calibrate the bed.
Wait for the temperatures of the nozzle and the Heated Bed to drop to room temperature (displayed on the
Touchscreen) . Remove the Print Sheet from the Heated Bed and bend it slightly.
3.3.3 Remove the Print
Guides & Pictures
/ Snapmaker
The nozzle and the Heated Bed are still extremely hot right after printing.
