52
|
Quick Start Guide
|
53
3D Printing
3.2.2 Load Filament
Guides & Pictures
/ Snapmaker
How It Works: Filament Loading
The motor drives the filament into the extruder, where the filament extrudes through the nozzle after being
heated by the heated block.
How to Load Filament
1. Hang the provided PLA filament over the Filament Holder. Cut the bending end of the filament using the
diagonal pliers, and then insert the filament into the 3D Printing Module.
2. Tap
Start
on the
Load Filament
screen. After the temperature reaches the target temperature, tap
Load
and
then gently push the filament into the 3D printing module until you can feel the motor pulling the filament in.
3. Clean the nozzle using the tweezers, and tap
Done
.
You can change the target
Nozzle Temp
by sliding the scale bar.
If no filament is coming out of the nozzle, do not tap
Done
until you repeat the steps above
and the filament extrudes successfully.
