Smiths Kelvin Hughes Nucleus 3 5000 Series, System Handbook

Page: 469 / 510

Re mote Trackerball (Desk top Control Pod)
84 The Remote Trackerball (Desktop Control Pod) is
fitted with a trackerball and three pushbuttons.
85
The trackerball is used to position the cursor on the
display screen. The pushbuttons are used to
activate/select a particular function. On-screen guidance on
which button to press, is provided in the Information Boxes
located in the lower centre portion of the screen. When first
displayed, after selecting RUN from STANDBY, the
information boxes show:
86
When a function is selected (e.g. Range Rings) the
Information box displays similar data to that in the
pop-down (information) boxes which appear below the
selected function box. If all pushbutton activities are the
same, a red box appears on the display containing the
legend:
87
A facility which has been previously activated, such as
EBL, is re-selected by positioning the cursor in close
proximity to the required facility and pressing the centre
pushbutton.
88
For further operating information, refer to Chapter 1 -
Nucleus 3 Displays - Operating Information.
Ra dar Sys tem ON/OFF Sounder Unit
89 The Radar System ON/OFF switch unit, is fitted with
an ON/OFF pushbutton switch and an audio speaker.
The audio speaker provides audible indications/warnings in
the same way as the audible speaker in the 5000 and 6000
series displays.
POWER ON/OFF
90 The Display only is switched ON using the ON/OFF
switch, located on the front of the Flat Panel Display
unit.
91
The Radar System is switched on using the ON/OFF
switch, located on the ON/OFF Sounder unit
(NNR-A65).
92
When the system is switched on, two short beeps
sound at the ON/OFF Sounder unit, to indicate that all
systems are functioning correctly. After a few seconds the
Standby Screen appears on the Flat Panel Display screen.
Original 8c.19 May 01
KH 2020
Chap 8c
ACQ ERBL Select
CD-2469
USE ANY KEY
CD-1964