Smiths Kelvin Hughes Nucleus 3 5000 Series, System Handbook

Page: 44 / 510

OWNSHIP SETUP
57 This facility allows Ownship to be shown on the radar
display in the correct dimensions and the antenna
correctly positioned in relation to the ship.
58 To edit the Ownship Graphics:
(1) Place the cursor over the TXA box at the top-left of
the screen. A pop-down information box appears
below. Press the centre pushbutton to put the
system into Standby Mode.
(2) In the Standby Mode, place the cursor over the
box GO TO MENUS box and press any
pushbutton.
(3) From the new menu that appears place the cursor
over the select the OWNSHIP SETUP box, and
press any pushbutton.
(4) A plan view representative of Ownship is
presented.
(5) To edit the length and the width of the ship, along
with the positioning of the antenna:
(a) Set switch SW1 to ON, place the cursor over
the dimension to be edited and press and
hold down any pushbutton. Increase or
decrease the measurement by the movement
o f t h e t r a c k e r b a l l u n t i l t h e r e q u i r e d
measurement is obtained, then release the
pushbutton. The length may be between 10
and 500 metres, with a width of 10 to 250
metres, switch SW1 OFF.
(6) The Ownship Graphics can be disabled by placing
the cursor over the Graphic ENABLED box, and
p r e s s i n g a n y p u s h b u t t o n . P r e s s i n g t h e
pushbutton over the box once again turns the
graphics back on.
(7) The Stern Marker can only be turned ON when the
Ownship Graphic is ENABLED and is only
displayed when the Range Scale in use is 3nm or
less. Once the Ownship graphic is enabled, the
Stern Marker can be turned ON by positioning the
cursor over the Stern Marker box and pressing
any pushbutton. Pressing the pushbutton over the
box once again turns the stern Marker OFF.
(8) To exit from the menu, place the cursor over the
EXIT box and press any pushbutton.
CURVED SETUP SCREEN
59
The Curved EBL is an Electronic Bearing Line that
graphically displays the rate of turn or radius of turn
that the vessel will take to effect a new course. The turn
shown will include the ship’s forwarding distance.
60 For information on setting-up the Curved EBL, refer to
Chapter 5 -Commissioning.
GO TO IN STALL SCREEN
61 Selecting GO TO INSTALL from the Standby Menus,
displays the Installation Screen. This facility allows the
selection of the Transmitter Type, Display Type, etc. To
define the system configuration.
NOTE:
This is not an operator function and is usually set during
system commissioning.
62
For information on Installation settings, refer to
Chapter 5 - Commissioning.
WATCH MON I TOR
63
This is used to alert the Operator that the integrated
bridge has not been used for a specified time period.
However, for this utility a particular connection is required to
the radar system. Refer to Chapter 5 for levels and default
setting information.
64 When there is inactivity exceeding the time period
specified in the setup, a
Red Warning appears:
65 If the trackerball is not moved within another thirty
seconds an additional
Red Warning appears.
NOTE:
This function requires the use of an optional watch alarm
controller, alarms are reset on all displays if any activity is
noticed.
May 01 1.8 Original
KH 2020
Chap 1
CD-4736
WATCH ALARM TRIGGERED MOVE TRACKERBALL
CD-2031
WATCH ALARM UNACKNOWLEDGED AFTER SPECIFIED TIME
CD-2032