FUNC TIONAL DE SCRIP TION
Low Ra tio Com pass PCB
68
The PCB accepts inputs from Synchro Compass
systems with ratios between 1:1 and 128:1. The
normal ratios used are 1:1, 36:1 and 90:1. Nucleus systems
can cater for 90:1 without this Low Ratio Compass PCB.
Mas ter/ Slave Adapter PCB
69
The PCB mainly comprises a number of Plugs, which
provide interconnections between the Master/Slave
PCBs, (if fitted, the Synchro Compass PCB), the Tx/Rx’s and
the Display System.
Mas ter/Slave In ter face PCB
70
The Master/Slave Interface PCB takes inputs of
Azimuth, Heading Line, Video and Sync from two
Radars and converts the inputs to the standard Display
requirements. The selection of Radar 1 or Radar 2 is
controlled from the Display.
NOTE:
(1) If Radar 2 has a Synchro or Resolver Azimuth, the
Synchro/Compass PCB must be used in addition to the
Master/Slave Interface PCB.
(2) If Radar 1 and/or 2 is 1024 pulse Azimuth the Divide by
4 PCB must be used in addition to the Master/Slave
Interface PCB.
Switches
71
The switch functions on the Master/Slave Interface
PCB are as follows:
(1) SW1 sets the division ratio for Radar 1 Azimuth,
using PLL.
(2) SW2 sets the division ratio for Radar 2 Azimuth,
using PLL.
(3) SW3 sets the Radar 1 Video for + ve or - ve signal.
(4) SW4 sets the Radar 2 Video for + ve or - ve signal.
Po ten ti ome ters
72
The potentiometer functions on the Master/Slave
Interface PCB are as follows:
(1) RV1, Radar 1 Video input to give +ve 5.5V
standard Video.
(2) RV2, Radar 1 Noise Level threshold for high noise
inputs.
(3) RV3, Radar 2 Video input to give +ve 5.5V
standard Video.
(4) RV4, Radar 2 Noise Level threshold for high noise
inputs.
(5) RV5, Radar 1 lock Delay.
(6) RV6, Radar 2 Lock Delay.
Mas ter/Slave Syn chro PCB Ra dar 2 only.
73
The PCB receives the input from a radar with 1:1
Synchro or Resolver azimuth transmission, and
converts it to 4096 pulses per aerial revolution for the
Master/Slave Interface PCB. The PCB also produces the
Heading Line.
Links And Switches
74
Links 1 to 6 are normally MADE for Nucleus fittings,
unless Table 5 indicates otherwise. The links may be
changed to vary the input voltage range of the PCB.
75
Switches 1 to 3 are used to adjust the Heading Line to
the correct angle.
(1) SW1, adjusts in 22.5 degree steps.
(2) SW2, adjusts in 1.4 degree steps.
(3) SW3, adjusts in 0.088 degree steps.
(4) Zero correction is with all switches in the F
position.
Di vide By 4 PCB
76
The PCB receives inputs of 1024 pulses per
revolution, from either Radar 1 or Radar 2, and divides
the input to produce 256 pulses per revolution for the
Master/Slave Interface PCB. The board also produces
Heading Line alignment correction.
Original
8a.19
May 01
KH 2020
Chap 8a
Summary of Contents for Kelvin Hughes Nucleus 3 5000 Series
