Smirnov Electronics | WhammyD 2 | User Manual EN
© 2013 SMIRNOV ELECTRONICS 37
10. Working in the MIDI Slave
Finding a MIDI input MIDI -‐ signal, WhammyD 2 immediately enters Slave -‐ it stops
transmitting MIDI Clock and MIDI Active Sense.
Communications received on
MIDI IN
, passed to the output
MIDI OUT / THRU
.
10.1 MIDI Clock mode Slave
In Slave mode, the pedal receives and calculates the tempo messages MIDI Clock -‐ 24
messages like System Real Time (0xF8) per quarter.
Reception and processing of these messages can not be disabled.
10.2 MIDI Active Sense mode Slave
In Slave mode, the pedal receives messages MIDI Active Sense -‐ message type System Real
Time (0xFE). In the absence of line
MIDI IN
other messages, sustain pedal able to Slave, it is
necessary to transmit MIDI Actibe Sense (0xFE) not less than once in every 300 ms.
Reception and processing of these messages can not be disabled.
10.3 Tune Request mode Slave
For accurate arpeggios used reset Real Time Tune Request message type (0xF6). Thus,
performance of the arpeggio stops.
10.4 Program Change mode Slave
Changing presets via MIDI 2 WhammyD possible by MIDI Program Change.
Room MIDI -‐ WhammyD channel 2 can be configured in the menu Options (User Manual
Section 3.5).
10.5 Continuous Controllers в режиме Slave
In WhammyD 2 can be controlled by several parameters for CC. For this numbers are used
CC, listed below.
1.
CC #0, CC #81
– control preset number of Digitech Whammy
2.
СС #11, CC #82
–control of position expression pedal of Digitech Whammy
3.
СС #28, CC #83
– arpeggio playback control (0-‐63: switches off arpeggio , 64-‐127
switches on arpeggios).
4.
CC #3, CC #84
– control button
А
(64-‐127 is treated as a single pressing the
A
).
