![background image](http://html1.mh-extra.com/html/smc-networks/idf190d-series/idf190d-series_operation-manual_1299707017.webp)
IDX-OM-X011
Chapter
3
Transportation and installation
IDF190D/240D Series
3.2
Installation
3-5
Power supply cable length
Power cable length for the product shall be less than 30m.
Power supply
Connect the power cable and grounding cable to the terminal block.
Wiring procedure
【
IDF190/ 240D-3
】
1) Remove the front panel.
2)
Introduce the cable through the grommet with membrane to connect to the terminal block. (refer to
the label on the terminal block)
Do not touch any equipment other than the terminal block during wiring. (Refer to the layout of the
terminal box).
3) Loosen the M4 screw of the terminal block using a screwdriver. Attach the round crimp terminal
(R5.5-4) attached to the power cable and tighten it to the terminal block with the previously loosened
screw.
【
Tightening torque:1.0N
・
m
】
4) Mount the front panel back.
【
IDF190/ 240D-9-
V
】
1) Remove the left panels.
2)
Insert the cable through the rubber grommet. Remove the transducer cover, then connect the cable
to the power supply transducer depending on the rated voltage. (Refer to the terminal block layout
below).
Terminal width
:
9.9mm
アース
お客様接続側
異 常
信 号
運 転
信 号
24
23
6
5
22
21
電源
遠 隔
運 転
PE
L3
L2
L1
端子台の配置図
Remote
operation
Gr
o
u
n
d
(to be connected to the user's equipment)
RUN
signal
Power
supply
Error
signal
(to be connected to the user's equipment)
Power supply transducer terminal layout
Terminal block screw: M5
Terminal width: 12.7mm
Power supply cable terminal location
Rated voltage
Power supply cable terminal
location
AC220V
u6, v6, w6
AC240V
u5, v5, w5
AC380V
u4, v4, w4
AC400V
u3, v3, w3
AC415V
u2, v2, w2
AC440V
u1, v1, w1