![background image](http://html1.mh-extra.com/html/smc-networks/idf190d-series/idf190d-series_operation-manual_1299707014.webp)
IDX-OM-X011
Chapter 3
Transportation and installation
3.2
Installation
IDF190D/240D Series
3-2
3.2 Installation
3.2.1
Environment
The product must not be operated or stored in the following conditions. Potential malfunction or damage
to the product may occur if these instructions are disregarded.
Place where the product is exposed to rain or wind. Humid place (more than 85% of relative
humidity).
Avoid locations where water, water vapor, salt water, or oil may splash on the product.
Avoid locations where dust or other particles are present.
Avoid locations where flammable or explosive gases are present.
Avoid locations where corrosive gases, solvents or combustible gases present.
Avoid locations which receive direct sunlight or radiated heat.
Avoid locations where the ambient temperature exceeds the limits as mentioned below.
During operation: 2 to 45
o
C
During storage: 0 to 50
o
C (when there is no drain water inside of the piping)
Avoid locations where temperature substantially changes.
Avoid locations where strong magnetic noise occurs. (Avoid locations where strong electric field,
strong magnetic fields, or surge voltage occur).
Avoid locations where static electricity occurs or conditions which make the product discharge static
electricity.
Avoid locations where high frequencies occur.
Avoid locations where damage is likely to occur due to lightening.
Avoid installation on machines used for transporting, such as vehicles, ships, etc.
Avoid locations at altitudes of 2000 meters or higher.
Avoid locations where strong impacts or vibrations occur.
Avoid locations where a massive force strong enough to deform the product is applied or the weight
from a heavy object is applied.
Avoid locations with insufficient space for maintenance.
Necessary maintenance space
Front face: 1.0 m
Rear: 1.0 m
Top: 1.0 m
Right side: 1.0 m
Left side: 1.0 m
Avoid locations where the ventilation grille is obstructed.
Avoid locations where the air dryer will draw in high-temperature air discharged from an air
compressor or other dryer.
Avoid pneumatic circuits where rapid pressure fluctuations or flow speed changes are generated.
3.2.2
Installation
The product should be installed on a vibration-free, stable, horizontal flat surface.
Refer to the 7.3 Dimensions of the Chapter 7.
We recommend the anchor bolt sets.
Do not use or store the product in conditions of compressed air or an environment
containing substances below. Otherwise, malfunction or parts damage may occur.
- Corrosive gas, organic solvents or chemicals.
WARNING