![background image](http://html1.mh-extra.com/html/smc-networks/idf190d-series/idf190d-series_operation-manual_1299707019.webp)
IDX-OM-X011
Chapter
3
Transportation and installation
IDF190D/240D Series
3.3
Cautions about Reinstallation
3-7
3.3 Cautions about Reinstallation
If you move the product and reinstall it into another place after some operations (including trial running),
all installation instructions in chapter 3 should be followed as well as the following instructions.
Disassembly of the power cable
Cut off the power source before you disassemble the power cable.
Removal of air piping
Remove the seal tape completely after detaching the piping. Remaining tape could cause imperfect
cooling or failure by entering into the product.
Procedure to release residual compressed air
1) Even while the dryer is removed, only when compressed air is needed, open the bypass piping valve.
2) Close the compressed air inlet and outlet valve.
3) Ensure that the ball valve of the auto drain is opened.
4) Open the bleed valve of the auto drain. When compressed air stops coming out, press the flush
button to confirm that there is no compressed air left inside. Refer to the figure shown below
Flush button
Bleed valve
Hexagon nut
Only someone who has enough knowledge about the equipment and incidental devices
should reinstall it in another place.
CAUTION
- All electrical work must be carried out in a safe manner by a qualified person in compliance
with applicable national regulations.
- Cut off the power supply for safety before the wiring. Wiring with the product energized is
strictly prohibited.
WARNING
- All electrical work must be carried out in a safe manner by a qualified person in compliance
with applicable national regulations.
- Separate the compressed air source from the product for safety before removing the
piping.
- Do not remove any piping when there is remaining compressed air pressure inside of it.
WARNING
Open
Close