(2)
Change of operation mode
of the base.
Enable the pairing setting of the remote registration on the base and reflect the change by
clicking the
Reset
button or by re-supplying power. Then, update the contents on the screen by
clicking the
Refresh
button.
(The remote information that can be registered is displayed in the Free remote area)
(3) Select the wireless channel
Register the required wireless channel by registering the remote on the base. Select the remote
and move it from the Free Remotes box to the Registered Remotes box.
(Registration is not complete at this point. The status of the remote will be shown as "Waiting for
registration").
(4)
Determination of the registered information
Press the Save reg-info to register the remote to the base.
Then, click
Refresh all
to confirm that the setting has been reflected.
(When the remote is registered correctly, the status of the selected remote will change from
"Waiting for registration" to "Registered".
(When the remote e-CON type is registered correctly, the mode will change automatically).
(5)
Change of operation mode
of the base.
Change the pairing setting on the remote registration screen of the base to "Pairing disable" and
reflect the change by clicking
Reset module
or by re-supplying power.
(6) Change of the normal mode of the grommet type remote
1. Disconnect the power connector and turn off the power.
2.
Connect the short jumper connector for the pairing cable.
3
.
Connect the power connector again to turn on the power.
Now, the registration procedure for the base and remote is complete.
When registering more than one remote is required, repeat procedures (3) and (4).
It is also possible to register more than one remote simultaneously to the base.
Summary of Contents for EX600-WD Series
Page 26: ...information is Simple or Detailed...
Page 42: ...Dimensions EX600 WD E1...
Page 43: ...EX600 WD A1...