○EX600-WDXA1
No.
Name
Application
1
Area close to NFC antenna
This area is in close contact with the NFC reader / writer.
"O" is the center of the NFC antenna.
2
Status LED
LED display to indicate the unit status.
3
Screw hole for mounting
(M5 x 4)
Used for installing sheet metals.
4
FG terminal
※
1
To be connected to Ground (for better noise immunity).
5
Power supply cable
Connect the power supply for control.
6
Input cable (E/F)
Connect the input equipment (M12 connector)
7
Input cable (C/D)
Connect the input equipment (M12 connector)
8
Input cable (A/B)
Connect the input equipment (M12 connector)
9
Input cable (8/9)
Connect the input equipment (M12 connector)
10 Input cable (6/7)
Connect the input equipment (M12 connector)
11
Input cable (4/5)
Connect the input equipment (M12 connector)
12 Input cable (2/3)
Connect the input equipment (M12 connector)
13 Input cable (0/1)
Connect the input equipment (M12 connector)
14 Pairing cable
Pressed when switching to pairing mode.
15 Short jumper
Connect the jumper connector in normal use, and disconnect the jumper
connector when pairing.
*1: Grounding should be as close as possible to the product and the grounding wire should be as short as possible.
*2:Attaching the waterproof cap (EX9-AWTS: not included) to any unused connector can satisfy the enclosure requirement.
Summary of Contents for EX600-WD Series
Page 26: ...information is Simple or Detailed...
Page 42: ...Dimensions EX600 WD E1...
Page 43: ...EX600 WD A1...