SMC Networks 8606SX - annexe 1, Management Manual

Page: 13 / 152

S
W ITCH
M
A NAGE MEN T
1-3
Configure the Remote Site
At the remote site, connect the PC’s COM port (COM 1~4) to the
modem’s serial port. Set terminal emulation type to VT100, specify
the port used by your PC (i.e., COM 1~4), and then set
communications to 8 data bits, 1 stop bit, no parity, 19200 bps and
no flow control.
In-Band Connections
Prior to accessing the management agent via a network
connection, you must first configure it with a valid IP address,
subnet mask, and default gateway using an out-of-band
connection or the BOOTP protocol.
Note: By default BOOTP is disabled. To enable BOOTP, see “IP
Configuration” on page 2-11.
Telnet Connection
Prior to accessing the management agent via an in-band Telnet
connection, you must first configure it with a valid IP address,
subnet mask, and default gateway using an out-of-band
connection or BOOTP protocol. After configuring the switch’s IP
parameters, you can access the on-board configuration program
from anywhere within the attached network.
Note: Use the Network Configuration menu to specify the
maximum number of simultaneous Telnet sessions that are
supported by the system (up to four).