SMC Networks 6128L2, Management Manual

Page: 141 / 606

U
SER
A
UTHENTICATION
3-87
learning. Be sure you enable the learning function long enough to ensure
that all valid VLAN members have been registered on the selected port.
Note that you can also restrict the maximum number of addresses that can
be learned by a port.
To add new VLAN members at a later time, you can manually add secure
addresses with the Static Address Table (page 3-140), or turn off port
security to reenable the learning function long enough for new VLAN
members to be registered. Learning may then be disabled again, if desired,
for security.
Command Usage
• A secure port has the following restrictions:
- Cannot use port monitoring.
- Cannot be a multi-VLAN port.
- It cannot be used as a member of a static or dynamic trunk.
- It should not be connected to a network interconnection device.
• If a port is disabled (shut down) due to a security violation, it must be
manually re-enabled from the Port/Port Configuration page
(page 3-111).
Command Attributes
• Port – Port number.
• Name – Descriptive text (page 4-144).
• Action – Indicates the action to be taken when a port security violation
is detected:
-
None : No action should be taken. (This is the default.)
- Trap : Send an SNMP trap message.
- Shutdown : Disable the port.
- Trap and Shutdown : Send an SNMP trap message and disable the
port.
• Security Status – Enables or disables port security on the port.
(Default: Disabled)
• Max MAC Count – The maximum number of MAC addresses that
can be learned on a port. (Range: 0 - 1024, where 0 means disabled)
• Trunk – Trunk number if port is a member (page 3-115 and 3-117).