SMART 3W72S2, Installation Manual, Page: 8 / 36

> the housing cover has been removed or can no longer be closed or locked,
> sufficient protection against splashing water and/or foreign objects is obviously no longer evident,
> there is functional or visible damage to the charging cable
> or the wallbox does not function properly or has been otherwise damaged.
DANGER!
Should you detect damage to the housing, charging socket or charging cable, you must
immediately discontinue installation or take the already installed wallbox out of opera-
tion via the upstream miniature circuit breaker(s) (in the following called MCB(s), see also
“Glossary & Definitions.” on page 27) in your domestic power supply and the RCCB: No
further use of the wallbox is permitted in this case! Please contact your local smart tech-
nical support!
Notes regarding installation.
Please observe the following instructions for the installation of your smart Wallbox:
> The device must always be connected to the protective earth conductor of your electricity supply.
The protective earth connection will be made and checked by the installing contractor. After instal-
lation, only qualified specialist electrical contractors may make changes.
> At all times comply with local safety regulations for the country in which you operate the wallbox.
> For proper operation, the power supply for the wallbox must be protected in the domestic power sup-
ply with suitable MCB(s) and RCCB.
> To disconnect the wallbox completely from the electricity grid, the power supply must be inter-
rupted using the upstream MCB(s) and RCCB.
> Ensure that the rated voltage and rated current of the device comply with the parameters of your lo-
cal electricity grid and that the rated output is not exceeded during the charging procedure.
> The wallbox should not be installed in areas of high pedestrian traffic. Installation along thorough-
fares and marked escape routes should be especially avoided.
> Never install the wallbox in a confined space. In particular, you must ensure that the vehicle can
be parked at a suitable distance from the wallbox for charging and connected without any strain on
the charging cable. The distance between vehicle and wallbox should be at least 50 cm and no more
than 5 m. You may deviate from this recommendation depending on the model variant of the wallbox
(length of charging cable) and local conditions.
> You must not under any circumstances make any changes to the housing or the internal wiring of
the wallbox: Any disregard of this instruction represents a safety risk, fundamentally breaches the
guarantee provisions and may void the warranty with immediate effect.