SMART 3W72S2, Installation Manual, Page: 13 / 36

smart Wallbox Preparations, installation and taking into operation 9
Proceed as follows to drill the holes using the mounting plate:
1. Ensure that a sufficiently dimensioned power supply is available at the desired installation site.
Otherwise, a power supply must be installed especially.
2. The mounting plate has pre-molded cable inlets
for the power supply on its upper edge as well in
the middle of its surface. According to the power
supply at the installation site (and as required),
please remove one of the plastic tongues in-
tended for the power supply cable with a suit-
able pair of pliers, a cutter or drill.
83
3. Place the mounting plate on the chosen mount-
ing surface: Use a spirit level if required. Mark
the drill holes.
4. Drill the mounting holes as marked (Ø 10 mm).
Insert the supplied wall plugs for the mounting
screws if required.
5. Fix the mounting plate in position with a screw-
driver (TX40 bit) and the wafer head screws (8 x
60)
included.
PLEASE NOTE: In case the power supply enters
from the rear, you must first thread the cable
through the opening in the connection area in
the lower third of the mounting plate before
screwing the plate into position.